Film Kiss Cutter

for most protective films such as refrigerators and home appliances


This is a special cutting machine that cuts the plastic protective film of the steel plate used for the exterior of the refrigerator, etc.

And it is fully automated cutter from steel plate loading to plate discharging after cutting plastic film, and removing the unnecessary cut film. 

(Film Remover is optional.) 

Shuttle transport system, instead of conveyor belts, makes the materials to be carried more quickly and accurately to desired location.

KKT (Kisscut Knife Tool) allows you to cut only the protective plastic film without damaging the steel plate underneath the film.



      Work Flow
1. Loader

The loader has two units on the left and right with suction pads that can lift steel plate materials. 

The two units can be operated together or separately depending on the size of the material. And there are 8 suction pads installed in one unit, and the suction position can be adjusted and suction can be turned on and off.


2. Alignment

Loader carries the steel plate on the alignment table. 

The two alignment blocks align the material according to the values set for each material size. 

The protruding alignment stopper (called an" island") located in the middle of the table can be hided under the table when using wide sheet. In the case of materials with short width and different sizes, two sheets can be used at the same time by lifting the island over the table as an alignment stopper.


3. Kiss Cutting Area

The shuttle under the table lifts the steel plate from the alignment zone and transports it to the next cutting zone.


In the cutting zone, KKT (Kisscut Knife Tool) can be used to cut only the protective plastic without any damage to the steel plate.


KKT Information 


4. Film Remover (Option)

The Film Remover automatically peels off the protective film of the steel plate kiss-cutted in the previous Kiss Cutting Zone.


At this time, the cylinder tongs specially made by DYSS pick up and lift the film clinging to the iron plate. And the suction tool (connected to the vacuum cleaner) next to the tong tool sucks up the film and carries it to the vacuum cleaner. Normally, the cylinderr tongs tool and suction tool are mounted on one head.


5. Buffer

The buffer zone is where the material is waiting before unloading to the discharge table. While waiting, it provides time for other zones to perform their respective functions.


6. Unloader

The unloader has the same structure and function as the loader.

The unloader unit lifts the material(s) waiting in the buffer zone and stacks them on the discharge table continuously.


Normally, the materials are stacked on a wooden pallet, and when the materials are piled up to a specified height, the machine is stopped by a sensor. At this time, the pallet is lifted by a forklift and transported to the designated location.


* Custom production is possible according to the size of material.
   Contact: sales@dyss.com